Building your own Vimana/Anti-gravity UFO for a few hundred $
Yo..just a note... on one of the essential ingredients for building anti-gravity craft. An essential one which was previously unavailable. Too expensive, too unreliable, difficult to apply, difficult to find.
That has changed.
The number I heard, IIRC, was that a RPM of about 50k was required on a spinning high mass fluid, in order to build up a gradient in the gravitational fields, for a Vimana to take off from the surface.
Well, now you can get ultra reliable 50k+ rpm 1600 watt/2hp
· archived 5/23/2026, 1:52:34 AMscreenshotcached html
Well, rotating solids will barely give you over-unity, it has to do with the fabric itself being of a very fine nature, and essentially fluid. On this planet, with the gravity gradient... that means a corkscrewed/vortex flow rate is required to 'overcome' it's fluidity, it cannot easily be done with a static function. So when trying to overcome it, we're talking about a stress loaded (field or similar) rotating fluid, so as to 'grab' it, to viciously couple. Hydrodynamic coupling. Like a rotating, vortexing, velcro-ish in act, viscous coupled at the quantum particle level. And then the high rpm of this spinning torus of viscous coupling. Previously, such motor arrangements would be custom or difficult to design and implement with no engineering or financial backing available. In this case, we have a easily obtained raw motor, that can be somehow applied to a given contraption that may be designed. I have no plans, just the motor itself is out there, and it can possibly inspire some who have had such ideas on their mind in one way or another. The thread is more of a public service announcement that reads like an advertizement of availability of a component. One of the key aspects of how it works, is revealed in a few data points. One being the dynamo experiment, which is inertially revealing. When a dynamo (DC motor, of a type) is sped up to a given specific high rpm and then stopped, and then 5-10 seconds later, it is re-started, the energy it takes to get to the prior speed is 'X'. When the dynamo is spun up to it's given specific high rpm, and then stopped very quickly..and then re-started immediately, as fast as possible, we find that after all the potentials in losses and speculated losses are calculated out, we still end up with the energy required to get back to the given specific rpm is...approximately 'X'-10%. What you have as a viscous coupled or shifted dark matter/aether field that is still spinning, or flowing, if you will. Your inertial characteristics between the two conditions of motor stop-and-start, have but one difference, and that is one of time. The backdrop, the fabric, with respect to the given frame of reference of the experiment....is Change/time. So at least the one clue is available. The reason I say dynamo over that of a dc motor, is that, loosely speaking, a uncontrolled DC motor design was the origin point of DC motors as we know them today, they were called dynamos. They had to be checked for run-away speed problems and they were still in the middle of designing for efficiency. Hundreds and hundreds of design efforts by many people, in many places. Some would speed up uncontrollably and blow apart at 100k rpm, or whatnot. The deal was that some of them, when getting into the uncontrolled accelerating speed condition... would begin levitating, or spinning upward, if not locked down. At the time, the experimental conditions had what is known as a 'dynamo pit', a large solid steel box or cement enclosure that would contain the exploding bits. It is the levitating bit that got out as a data point (and the runaway acceleration) and is the more incredulous part of the story, along with the 10% stop-start timing scenario, that together ....would begin to point the way. also, counter-rotating systems can be built with sliding angled systems of magnetic interaction, and one could get a a net thrust effect. Think of two DNA strands, one inside the other, but of a mirror build of the twist. Like a caterpillar drive but for gravity. An accelerated shearing effect, DNA counter-rotating squeeze/scissors. Just some potentials in investigation points. Spin the pair opposite to one another and possibly get a caterpillar drive with a shearing effect in the magnetics that may be fast enough to overcome gravity's compensation in it's dynamic fluid flow state. it's about viciously coupling past the requisite speed or rate. remember the pyramid and it's shape, and what happens when you put one on top of something like a Tesla coil/generator system. You get the dual spiral pattern coming out of the interaction between 'the space' (in what we call air) and the solid, the geometric shape of the copper cap. Think optical/fluid/motional interaction. Thus the field characteristics of the system//the witnessed dual helix pattern.... indicate a flow pattern of the dark matter/space/gravity/time field.